Operating Access Points In Managed Mode; Status Displays, Interfaces An Hardware Installation; Status Display - Lancom 850 UMTS Manual

LANCOM 3850 UMTS
Chapter 2: Installation
2.2.2

Operating access points in managed mode

LANCOM Wireless Routers and LANCOM Access Points can be operated either
as self-sufficient Access Points with their own configuration ("Access Point
mode") or as components in a WLAN infrastructure, which is controlled from
a central WLAN Controller ("managed mode").

2.3

Status displays, interfaces an hardware installation

2.3.1

Status display

Meanings of the LEDs
In the following sections we will use different terms to describe the behaviour
of the LEDs:
Front side
The LANCOM Wireless Routers have status displays on the front panel.
20
For operation in managed mode the Access Points require firmware of
version 7.22 or higher and a current loader (version 1.86 or higher).
Blinking means, that the LED is switched on or off at regular intervals in
the respective indicated colour.
Flashing means, that the LED lights up very briefly in the respective
colour and stay then clearly longer (approximately 10x longer) switched
off.
Inverse flashing means the opposite. The LED lights permanently in the
respective colour and is only briefly interrupted.
Flickering means, that the LED is switched on and off in irregular inter-
vals.
³ » ¿´² ¶
3850 Wireless