Gathering Fabric To Fabric - Bernina 1200DA Owner's Manual

M
ASTERING
Y
OUR
BERNINA
®
• Owner's manual pg.___
• Thread the serger for a 4-thread balanced overlock stitch.
• Adjust as indicated on the LCD screen. Fine tune as needed.
• Raise the upper knife and adjust the cutting width to 3mm.
• Locate and loosen the silver fixing screw in front of the rolled hem stitch selection dial.
• Slip the Gathering Attachment on to the fixing screw and metal post directly behind the fixing
screw. Hint: Attach the horseshoe-shaped slot over the screw and then rotate the attachment to
lock over the metal post. Tighten the fixing screw.
• Return cutting width to 2mm (normal) and lower the upper knife into cutting position.
• Locate and adjust the differential feed dial to 2.
• Raise the presser foot and insert the 14" strip of fabric (right side up) under the Gathering Attachment.
The fabric is lying next to the stitch plate. Sew several stitches until the fabric is under the needles.
• Turn the handwheel to lower the needles. (This also lowers the feed dog.)
• Place the 8" strip of fabric (right side down) on top of the Gathering Attachment and under the presser
foot with the end of the 8" strip touching the needles.
• Serge the two strips together; the lower strip will gather as you sew.
• Trim and mount the sample.
• Return all settings to normal.
BERNINA
M Y
ASTERING OUR
THE GATHERING ATTACHMENT

Gathering Fabric to Fabric

Fabric: Medium weight cotton, 3" x 14"
Medium weight cotton, 3" x 8"
Needle: 80/12 Universal, Sharp, or Microtex
Thread: 4 cones of serger thread
Presser Foot: Standard
Attachments: Gathering Attachment (optional accessory)
Stitch: #1 (4-thread overlock stitch)
6/01/02
®
BERNINA
®
1200DA/1300DC
1200DA/1300DC/33