Wire-Edged Fabric - Bernina 1200DA Owner's Manual

M
ASTERING
Y
OUR
BERNINA
®
• Owner's manual pg.___
• Thread the serger for a narrow 3-thread rolled hem (right needle) with Woolly Nylon in the
upper looper.
• Adjust as indicated on the LCD screen. Fine tune as needed.
• Pull the rolled hem dial towards you.
• Adjust the stitch length to 1.75mm.
• Set cutting width at 2 (normal).
• Attach the Cording Foot.
• Following the direction in the instruction leaflet for the Cording Foot, insert the wire through the
guides.
• Place the fabric under the presser foot and serge along one 18" edge, feeding the wire through
the foot as you serge.
• Use wire cutters to cut the wire. Do not use the serger knives.
• Repeat for the other 18" edge of the fabric.
• Return stitch length and thread tension dials to normal.
• Return the rolled hem dial to normal sewing position.
• Secure the thread tails with a seam sealant. When the sealant is dry, cut the thread tails. Use
wire cutters to trim the wire, if needed.
• Tie the wired fabric into a bow.
• Trim and mount the sample.
BERNINA
M Y
ASTERING OUR
BERNINA
CORDING FOOT

Wire-Edged Fabric

Fabric: Medium weight fabric, 3" x 18"
Needle: 80/12 Universal
Thread: 2 cones of serger thread
1 cone of Woolly Nylon
28 gauge floral wire
Presser Foot: Cording Foot (optional accessory)
Stitch: #8 (3-thread rolled edge)
6/01/02
®
®
1200DA/1300DC
1200DA/1300DC/56