Enabling Lldp And Lldp-Med On The Switch - Allied Telesis AT-9028 User Manual

At-9000 series layer 2-4 gigabit ethernet ecoswitches
Table of Contents

Advertisement

Chapter 61: LLDP and LLDP-MED

Enabling LLDP and LLDP-MED on the Switch

To enable LLDP and LLDP-MED on the switch, use the LLDP RUN
command in the Global Configuration mode. The switch begins to transmit
advertisements from those ports that are configured to send TLVs, and
begins to populate its neighbor information table as advertisements from
the neighbors arrive on the ports. The command does not support any
parameters. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# lldp run
To deactivate LLDP and LLDP-MED, refer to "Disabling LLDP and LLDP-
MED on the Switch" on page 904.
884
Section X: Network Management

Advertisement

Table of Contents
loading

Table of Contents