DCS 43" Installation Manual page 11

1
~
burner box. From the back of the unit with the
back guard removed, remove the infrared broiler
orifice with a 1/2 inch open end wrench and
replace with the black coded orifice supplied
(wired to the tubing in the rear). Tighten until
snug.
along with the U? orifice (color coded black).
To install the air s;hutter, remove the mounting
screws, slide the air shutter in place from the side,
-See Fig. 12. Ne)!:t, replace the mounting screws.
Ensure that the air shutter rests flat on the orifice
elbow bracket. (It may be necessary to rotate the
mounting nut on the orifice elbow slightly until
flush)
.~RNll~
The air shutter is .for L.R Gas use only. Remove if
converting a L.R IGas unit back to Natural Gas.
OIMPORTANT!!!!
GAS CONVERSION INSTRUCTION
Oven Broiler Burner
OPEN TOP BURNERS
Tighten all cooktop main bl,lrner orifice hoods
down until seated against the integral predrilled
L.P. pin. ~See Fig. 20. A 1/2" deep well socket is
ideal for this purpose. Do not over tighten.
Replace oven burner orifice and oven broiler ori-
fice with orifices supplied as described in steps 5
&6.
The Range is shipped from the factory set for
Natural Gas. When converting the appliance to
L.P. gas, it is necessary to install the factory sup-
plied air shutter on the oven broiler burner ven-
turi. The air shutter is located at the back of the
unit attached to the oven broiler burner tubing