Using Can-Bus - Classe Audio Sigma Series Owner's Manual

using CAN-Bus CAN-Bus is controlled via the touchscreen of any Classé component that is
18
The diagrams below illustrate how to connect the CAN-Bus hardware.
Any combination of models in any order.
For any system with SSP-300 or SSP-600.
NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.
so equipped. There is no master component, so Classé series systems where
two or more units have a touchscreen can be controlled through any of the
touchscreens. However, it is probably easiest to start using CAN-Bus through
just one.
CAN-Bus is accessed by pressing the menu button on the face of the unit or
remote, then the status button, followed by the more button.
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT