Installation Instructions - 70Cm; Prepare For Installation - Belling GAS B Service Manual

INSTALLATION INSTRUCTIONS - 70CM

Before you start - please read the
instructions carefully - planning your
installation will save you time and effort.
Look at the different ways the appliance
can be installed - as shown on the
following pages - and plan the installation
to suit your situation.
Leave the appliance in the base tray
packaging until you are ready to install
it. When you remove the appliance from
the base tray packaging, take care not to
damage it.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective gloves
during installation.
Please note that the weight of this
appliance is approximately 47kg
(unpacked). Take care when lifting it
into the housing unit - always use an
appropriate method of lifting.
This appliance must be installed only
at low level - ie; under a worktop. The
controls have been designed for viewing
at a low level, and it should therefore not
be installed at high level.
Please note that all dimensions and sizes
given are nominal, some variation is to be
expected.
Quantity Colour
6 Silver
12 Black
6 Black
2 Silver
If this appliance is to be installed near to
a corner where the adjacent cabinets run
at right angles forward of the appliance,
there must be a gap of at least 90mm
between the appliance and the cabinets,
to prevent overheating of the cabinets.
Important: Do not modify the outer panels
of this appliance in any way.
Fixing screws - The fixing screws are
in a polythene bag in the oven pack.
Depending on the method of installation,
some of the screws may not be needed.
Step 1: Prepare for installation
There are 3 methods of installing the
appliance:
Method 1: Into a space between two base
units, ie; without a housing unit.
Method 2: Into a housing unit, with an
internal height of less than 710mm, which
can be modified to obtain the required
dimensions.
Method 3: Into a housing unit, with an
internal height of 710mm or more. If
you have a non standard size of cabinet
which leaves a gap above or below the
appliance, you may be able to buy a trim
kit (to fill in the gap) from the supplier of
your cabinets.
Description
No 8 x 12mm long Self
tapping screw
No 8 x 12mm long
Chipboard screw
No 8 x 25mm long
Chipboard screw
No 8 x 12mm long Self
tapping screw
For Fixing
Runners to appliance
Runners and sidetrims
to cabinet or housing
Appliance to cabinet
Appliance to sidetrims