Without Housing Unit - Belling GAS B Service Manual

INSTALLATION INSTRUCTIONS - 70CM
Method 1: Without housing unit
(between 2 base units)
Before installing the appliance, check the
internal dimensions as shown.
The space for the appliance must be clear
of obstruction. You may have to cut into or
remove any rear cross members to obtain
the 550mm minimum depth.
The Fixing Kit
Should you need a replacement fixing kit
please call the customer care helpline and
order part number: 01 28287 00.
In the fixing kit you will find 2 side trims
(687mm long) and 4 runners (420mm
long). The fixing screws are in a polythene
bag in the oven.
1. Take the 6 No 8 x 12mm (silver) self
tapping screws from the polythene
bag, and use them to fit one runner to
each side of the appliance.
2. Make sure they are the right way up as
shown.
3. Take one of the side trims, hold it
against the side of the base unit, and
mark off 687mm from the top edge of
the base unit, to the top edge of the
runner.
Note: This ensures a 5 - 8mm
clearance from the underside of the
worktop to the top of the appliance.
4. Measure 50mm from the front edge of
the base units, to mark the front edge
of the runners.
5. Take 6 of the No 8 x 12mm (Black)
chipboard screws and screw the
runners into opposition the right way
up as shown.
6. Fit the side trims to be flush to the top
and front edges of the base units,
using the remaining 6 No 8 x 12mm
(Black) chipboard screws.