Belling GAS B Service Manual page 29

INSTALLATION INSTRUCTIONS - 60CM
i) When installed in a typical 600mm
deep built in housing unit, the false
back should be removed from the
housing unit to provide the necessary
depth for installation.
ii) When the false back is removed, it is
normally the case that the support
shelf for the appliance leaves a gap
between the back edge and the wall of
approximately 80mm.
iii) If no gap occurs between the back
edge of the shelf and the wall behind
the unit, we recommend that a gap of
at least 30mm is made by shortening
the shelf.
iv) When installing the appliance below a
worktop, there must be a minimum
ventilation area of 60cm2 below the
appliance, in either area (1) or (2), as
indicated below. There must be a
5mm gap between the front top edge
of the oven and the underside of the
worktop.
Important: Do not modify the outer panels
of this appliance in any way.
Ensure that you route all mains electrical
cables and flexible tubing well clear of any
adjacent heat source, such as an oven,
grill or hob.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Installing the appliance under a worktop
Where the appliance is installed under
a worktop, with a hob installed above it,
the installation instructions for the hob
must be read in conjunction with these
instructions.