Housing Unit With Internal Height 710Mm Or More - Belling GAS B Service Manual

INSTALLATION INSTRUCTIONS - 70CM
Method 3: Housing unit with internal height
710mm or more
Note: You will not need the 4 runners and
2 trims that are packed with the oven for
this installation.
1. When installed in a typical 600mm
deep built in housing unit, the false
back should be removed from the
housing unit to provide the necessary
depth for installation.
2. When the false back is removed, it is
normally the case that the support
shelf for the appliance leaves a gap
between the back edge and the wall of
approximately 80mm.
3. If no gap occurs between the back
edge of the shelf and the wall behind
the unit, you must create a gap of at
least 30mm by shortening the shelf.
Remove any fixings that may prevent
entry of the oven into housing, or obstruct
the gas inlet pipe. The cabinetry should
be kept structurally sound by fixing to
adjacent cabinets, floor or worktop.