Stabs/Elevator Assembly - AeroWorks Extra 260 Manual

STAB AND ELEVATOR
ASSEMBLY
1. The elevators have been pre-hinged and glued
to the stabs and are ready for flight. No other
steps are necessary for hinging. Gather the
items shown below for the elevator linkage
installation
Required Parts
◊
2 - Double Truss Carbon Control
Horn- Single output
◊
1 - Control Horn Base Plate
◊
1 - 2.5" 4-40 Adjustable Pushrod
◊
2 - 4-40 Ball Links
◊
2 - 4-40 Bolts
◊
2 - 4-40 Lock Nuts
◊
1 - Brass Spacer
◊
1 - 3mm Flat Washer
Required Parts-Not Included
◊
1 - Elevator Servo
◊
4 - Servo Mounting Screws (Micro Fastener
Part number STW0209 recommended)
◊
1 - 1 1/4" Servo Arm
◊
1 - 24" Servo Extension
◊
1 - Aeroworks Safety Clip
Required Tools and Adhesives
◊
80 Grit Sandpaper
◊
5 Minute Epoxy
◊
Hobby Knife
◊
Ball Point Pen
Aeroworks 30cc Freestyle Extra 260 Assembly Manual
2. Attach the 24" servo extension to the servo wire
and secure using an Aeroworks Safety Clip.
3. Lay out servo and extension to verify servo ex-
tension length before installing servo.
4. Attach elevator servo extension to pre-installed
pull string as shown.
5. Pull servo extension through fuse and into radio
compartment.
6. Install servo in servo well with the output shaft
towards the rear of fuse as shown below.
7. Using a 1/16" drill bit, drill holes for servo
screws.
8. Install servo with servo mounting screws
11