Stabs/Elevator Assembly - AeroWorks EXTRA 260 FREESTYLE QB-L User Manual

STAB/ELEVATOR
ASSEMBLEY
1. Gather the items shown below for the installa-
tion of the Stabilizer and Elevator.
Required Parts
◊
1 - Horizontal Stabilizer
◊
1 - Elevator Assembly
◊
6 - CA Hinges
◊
1 - Carbon control horn- Single
Required Tools and Adhesives
◊
12 - Medium T Pins
◊
1 - 1oz Bottle Thin CA Glue
◊
1 - 1oz Bottle Thick CA Glue
◊
1 - Ball Point Pen
◊
1 - Ruler
◊
1 - Tape Measure
◊
1 - 80 Grit Sand Paper
10
2. Slide elevator into fuse slot as shown.
3. Push the elevator all the way back into the
stabilizer cutout as shown.
4. The stabilizer has a locator dowel built into the
leading edge. This locator dowel must key into
the locator block in the fuse. This will ensure the
front of stab is centered in fuse.
5. Slide the stab into the fuse cutout as shown. Be
careful not to damage the front locator pin while
sliding the stab in place.
52" Aeroworks Extra 260 Freestyle Assembly Manual