AeroWorks Extra 260 Manual page 38

6. Trace around the head of the engine being care-
ful to keep the template in the same location.
7. Use a hobby knife to cut out the engine cylinder
exit opening as shown.
38
8. Check the fit of the template at this time. It may
be necessary to make small adjustments to the
cut out to get it to fit properly.
9. Align template with mounting bolt holes in cowl.
Use a felt tip marker to transfer the template cut-
out pattern to the cowl and mark cut location.
Note: Pay close attention to the marker you
choose. Some permanent markers may not
be easily removed. Also, When using
rubbing alcohols or other paint removers,
always test on painted parts before using!
10. Remove the template and use a rotary cutting
tool and sanding drum to cut out the openings in
the cowl.
11. Temporarily mount cowl to fuse, ensure that the
cowl does not come in contact with the engine
and that there is at least 1/4" of clearance be-
tween the cowl and the motor. Make any adjust-
ment to the cylinder head cut out at this time.
Aeroworks 30cc Freestyle Extra 260 Assembly Manual