AeroWorks Extra 260 Manual page 40

19. Tilt the cowling down to allow the stingers to
pass through the cowling. Push cowling up and
over the propeller drive shaft until it is in place.
20. Bolt cowling in place and check the stinger exit
location at this time. If the cowling comes into
contact with the exhaust at any point, remove
cowling and enlarge the stinger cutout for a
proper fit.
40
21. Locate the supplied front air inlet template and
tape to cowl using masking tape.
22. The front air inlets should be centered both verti-
cally and horizontally on the engine head. This
will allow cool air to pass through the cowl and
into the fins of the engine.
23. Use a rotary cutting tool to cut out front air inlets
as shown below.
24. Finished cowl installation shown below.
Note: Aeroworks has found this method to provide
sufficient cooling for the DLE 30 gas engine.
It is still important to check motor
temperatures to ensure it is not running too
hot. If your engine does run hotter than the
manufacturer suggests, additional cooling
holes may need to be made in the cowling.
Aeroworks 30cc Freestyle Extra 260 Assembly Manual