AeroWorks Extra 260 Manual page 10

15. Install servo with servo mounting screws. Re-
peat servo installation process for remaining
aileron servo.
16. Tape the aileron in place as shown. This will
help keep the aileron centered while making the
initial linkage adjustments.
10
17. Install ball link to 1 1/4" servo arm, correct in-
stallation of ball link to servo arm shown below.
Note: Flat washer will prevent ball link from
coming loose from brass ball.
18. A pushrod adjustment wrench has been in-
cluded, this will allow the pushrod length to be
extended or shortened with out removing the
servo arm. Adjust the pushrod length so the con-
trol surface is neutral when the servo arm is 90
degrees to the servo case.
19. Final aileron servo installation shown below,
repeat all previous steps for the remaining wing
assembly.
Note: On metal geared servos use Loctite for all
servo arm mounting screws.
Builders Tip:
If using Hitec Servos, replace phillips head servo
arm screw with a socket head screw. This will allow
for easier removal at a later date. These screws can
be purchased from Micro Fasteners part number:
SCM2508
Aeroworks 30cc Freestyle Extra 260 Assembly Manual