Matrox MXO2 Installation And User Manual page 60

48
$
Under Channel Selection , select the video channel (main or SD) that you
5
want for your MXO2 Mini analog (composite, S-Video, and component) and
HDMI outputs:
$
$
¦ Note
576p respectively (see
Formats").
Under Channel Behavior , select the Pulldown method that you want to
6
be applied to the video output when required to convert 23.98 fps video. For
information on the available pulldown methods, see
"Understanding
Under Channel Behavior , select the 16:9 to SD aspect ratio conversion
7
option to be used when downconverting 16:9 material to SD, or when
outputting SD 16:9 material:
$
$
$
Under Miscellaneous , select First field , Second field , or Both fields
8
from the Scrub and pause menu to indicate whether you want to display
both fields or only one field when pausing video playback or scrubbing the
timeline in your project. For example, you may want to scrub the first or
second field to eliminate the flickering that can be seen in your picture when
you pause while scrubbing interlaced video.
From the Set HDMI output to menu, select YUV or RGB to set the type of
9
video that is sent from MXO2's HDMI output. For example, select RGB if
your MXO2's HDMI output is connected to an HDMI device that accepts an
RGB signal.
Chapter 6, Installing Your MXO2 Software and Configuring Your System
Sets the main channel's video output to a 1080i or 1080PsF
1080
format, depending on your project's video output format.
Outputs your project's video as defined for the main
Main channel
channel (see step 3).
SD channel Outputs your project's video as NTSC or PAL, depending
on your project's video output frame rate.
On the HDMI output, NTSC and PAL video is output as 486p and
Appendix D, "Matrox MXO2 Supported Output
Pulldown."
Outputs the widescreen 16:9 picture in letterbox mode by
Letterbox
adding black bars at the top and bottom of the picture for display on a
standard 4:3 television screen.
Center cut Outputs the widescreen 16:9 picture by evenly cropping the
left and right edges of the picture for display on a standard 4:3 television
screen.
Outputs the widescreen 16:9 picture as horizontally
Anamorphic
compressed 4:3 video, which retains the picture's full vertical resolution
for display on a widescreen television. To display the video with the
correct proportions on an NTSC or PAL monitor, select the 16:9 display
setting on the monitor.
Appendix A,