Remotes And Two-Way Keyfobs - Cooper Security i-on40 Administrator's And User Manual

4. Administration
However, the sequence of
key presses is the same for
all i-on control units.
8. Press  or  to display the
output you wish to test.
a). Press .
The keypad gives a double
"beep" confirmation tone. The
keypad display shows:
The control unit turns on the
output. Check that that it is
working as expected.
Note: Outputs connected to radio
output modules may take
several seconds to change
state.
b) Press  again to turn the
output off.
The keypad gives a double
"beep" confirmation tone. The
keypad display shows:
9. Press  to end the test.
NOTE: Make sure no one tries to activate an output by means of
a remote control while you perform the test.
When you complete the test check that the output is back
in the state it had before testing. For example, if the output
was off before testing, make sure it is off after testing.

Remotes and Two-way Keyfobs

1. Make sure the display shows
the standby screen.
2. Press .
Page 70
i-on40 & i-onEX Range











