If You Cannot Reset The System - Cooper Security i-on40 Administrator's And User Manual

i-on40 & i-onEX Range
If you return to the control unit
after the sirens have stopped and
key in your access code then the
red LEDs around the navigation
keys glow to tell you that an alarm
has occurred.
Press  or  to see the name of
the zone (if the installer has
programmed one), for example:
Press  to restore the display to
normal.
If you wish to see any other zones that were triggered during the
alarm, look in the log (see page 61).

If You Cannot Reset the System

Your system may be programmed so that it has to be reset by
the installer after an alarm.
If the top line of the
display shows:
Then contact your alarm
installer.
The installer will either come to your site and reset the system
for you, or, if the system has a suitable communicator fitted,
send a signal to the control unit to allow you to reset the
system.
Remote Reset (aka Anti-Code Reset)
The installer may have programmed your system so that they can
give you a special code to reset the alarm system.
The screen will tell you where the
alarm occurred, for example:
It will also show a message asking
you to call the alarm company, for
example:










2. Alarms
Page 17