Using The Scanner Out Of The Stand; Resetting The Defaults - Honeywell 4850DR Manual

Using the Scanner Out of the Stand

If you remove the scanner from the stand to read bar codes, you should hold it closer to the bar code. The optimum read
range is 9 to 11 inches (22.86 to 27.94cm). Since this is primarily a document imager and works like a camera, you must
hold the scanner steady when scanning bar codes out of the stand.

Resetting the Defaults

If you want the factory default settings restored to your device, scan the Activate Custom Defaults bar code below. This is the
recommended default bar code for most users. It resets the device to the custom default settings. If there are no custom
defaults, it will reset the device to the factory default settings.
Activate Custom Defaults
1 - 3