Removing The Bezel - IBM System x3800 Installation Manual

Top cover
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you are installing or replacing a non-hot-swap component, turn off the server
3. Lift the plastic cover-release latch near the edge of the top cover.
4. Slide the top cover slightly toward the rear of the server; the cover will stop after

Removing the bezel

On a tower model, make sure that you unlock or remove the front cover before you
remove the top cover and bezel.
To remove the bezel, complete the following steps:
on page 7.
and all peripheral devices. Disconnect all power cords; then, disconnect all
external cables from the server.
moving approximately 25 mm (1 inch). Lift the cover off the server, and set the
cover aside.
Attention: For proper cooling and airflow, replace the top cover before turning
on the server. Operating the server for more than 2 minutes with the top cover
removed might damage server components.
Cover release
latch
Chapter 2. Installing options
11