General Information; Gas Consumption; Burner Pressures - BONAIRE Installation Instructions Manual

I

General Information

Name of appliance: Bonaire & Pyrox 3 & 4 Star Gas Central Heater
Models: MB314iNG, MB320iNG, MB330i NG, MB330i NG X/A, MB314e
NG, MB320e NG, MB330e NG,
MB414i NG, MB420i NG, MB420i NG X/A, MB430i NG, MB430i
NG X/A, MB414e NG, MB420e NG, MB430e NG, MB430e NG X/A.

Gas Consumption:

Burner Pressures:

Gas Connection: Connection on gas valve is via ¾" BSP (female) flare nut
When connecting the gas supply inlet pipe to the gas valve, hold the
connection nipple on the valve with a spanner while tightening the inlet pipe
compression nut. This ensures the nipple is not over tightened. Cracked
gas valves or regulator castings due to over tightening during
installation or service are not the manufacturerʼs responsibility.
Statutory Requirement: This product must be installed only by
an authorised person and in accordance with the current editions
AS/NZS 5601 & AS/NZS 3000.
DO NOT OPERATE THIS APPLIANCE BEFORE READING THIS
GENERAL INFORMATION & INSTALLATION BOOKLET.
Checking Supply & Burner Pressures:
Refer to data plate on the product for burner pressures.
NOTE: All wiring coming out of the unit (mains power lead, thermostat
wiring etc...) must be fully extended and securely anchored using the cable
tie provided.
14i unit – 60MJ/h
20i unit – 80MJ/h
30i unit – 120MJ/h
onto which the inlet pipe and ¾" manual shut-off valve
(Refer to AS/NZS 5601) Use only gas copper pipe which
complies with AS 1432 Type B.
2
Part 5442225 issue E