14
Zones Setup (cont)
NOTE: There is no difference in setup between a wall mounted wired and wireless
remote Navigator installation.
MULTIPLE NAVIGATOR CONTROLLERS – UPSTAIRS DOWNSTAIRS CONFIGURATION
This feature allows two Navigator Controllers to be used to control an installation with
a common zone downstairs and one or more damper controlled zones upstairs. Both
Navigators have equal control over the system and the last change made on one
Navigator will be copied to the other Navigator to keep the system in synchronisation.
(Note that with remote thermostats, the change may take some minutes to appear on
the second Navigator while they are in the "sleep" state. The heater will respond
immediately to any change).
To enable this feature for a two damper installation,
1. Pair the common zone (downstairs) Navigator Controller.(Remote only)
2. Join the upstairs zone Navigator Controller to the common zone
controller.(Remote only)
3. Set the parameters as per the following table,
Navigator 1 Controller Installer Parameters
Parameter
Unswitched(common) Zone
Switched Zones
Temperature Display Zone
Temperature
Common Zone
Temperature
Switched Zones
Navigator 2 Controller Installer Parameters
Parameter
Unswitched (common) Zone
Switched Zones
Temperature Display Zone
Temperature
Common Zone
Temperature
Switched Zones
Heater Installer Parameters
Parameter
Unswitched (common) Zone
Switched Zones
Id
1
2
3
Measurement
–
4
Measurement
–
5
Id
1
2
3
Measurement
–
4
Measurement
–
5
Id
1
2
Value
Meaning
1
Common zone present
3
Zones 1 & 2 available
0
Displaying
zone
1
Measurement from common zone
0
Not Measuring other zones
Value
Meaning
1
Common zone present
3
Zones 1 & 2 available
1
Displaying temperature in zone 1
0
No measurement from common zone
3
Measuring zones 1 & 2
Value
Meaning
1
Common zone present
3
Zones 1 & 2 available
19
temperature in common
Part 5442225 issue E