Multiple Navigator Controller 9 Operation; Operation Of Multiple Navigator Controllers; Multiple Wireless Remote Controllers; Joining Navigator Controllers - BONAIRE Installation Instructions Manual

9

Multiple Navigator Controller 9 Operation

OPERATION OF MULTIPLE NAVIGATOR CONTROLLERS

The Navigator control system is capable of supporting up
to 4 controllers. By default, the system will allow one
controller to control the appliance or multiple appliances.
Certain parameter set ups must be made to configure
multiple controllers.
The options available are
• 2 wired Navigators only
• 1 wired Navigator and up to 3 Remote Navigators.

MULTIPLE WIRELESS REMOTE CONTROLLERS

In a multiple Navigator controller system, the other
controller may be joined to a master by putting the slave
controller into a PAir mode. It will then send out a PAir
request to the master controller. The master controller is
then put in a JOin state and can then join the request to
set up a Navigator system.
JOINING NAVIGATOR CONTROLLERS (JO
Controllers requesting to JOIn another controller in the
Navigator system, can be put in the join mode as follows.
1. To enter the JOIn state, press and hold the ENTER
button for 3 seconds & release.
2. Press and release the, MODE, HEAT/COOL and
SETUP buttons in sequence.
3. The master wireless Remote controller should display
JOin state to receive a command from the other
handset to JOIn the Navigator system.
4. The slave controller should be placed into a Pair state
to join with the master controller. The slave controller
should display Pair.
)
IN
12
Part 5442225 issue E