Accessing Navigator Controller Installer Setups - BONAIRE Installation Instructions Manual

10

Accessing Navigator Controller Installer Setups

NOTE: The Navigator Controller must be in the OFF
status to change the parameters.
1. Press and hold the ENTER button for 3 seconds.
2. Press & release the Ï then Ð then SETUP
buttons to enter the installer set up mode.
3. The word "InST", "nSTA", "STAL", "TALL",
"ALLE", "LLEr" (Installer) scrolls across the upper
part of the display. Press the ENTER button.
4. When the CodE "11 11" appears, input the code
"98 76" using the Ï and Ð buttons to select each
digit, and press the ENTER button to move to the
next digit
NOTE: The Navigator Controller will display
the
appliance such as "EC XX" for
Evaporative Cooler, "HE XX" for
Central Heater or "th XX" for the
Navigator controller settings ("XX" is
the
example "th 06".
5. Use the Ï and Ð buttons to scroll to the "th XX"
and then press the ENTER button to access
Navigator Installer setup.
The display will now show digits "1 1". The lower left
digit is the parameter number and the lower right digit
is the parameter option value. Parameter numbers
and option values can be found in the Navigator
Controller Installer Parameters Table.
6. To select the parameter number use the Ï and Ð
buttons to find the desired parameter and press
ENTER.
7. Adjust the option value (See Navigator Parameter
Table) to the required value and press ENTER.
This will set the option value and return you to the
parameter number selection menu.
When finished Press the ON/OFF button to exit.
8.
abbreviated name
unique serial number).
of the
For
Parameter
Number
13
Options value
Part 5442225 issue E