Viewing Recorded Videos Immediately (Clip Review) - JVC GY-HM790CHU Instructions Manual
Hd memory card camera recorder
Hide thumbs
Also See for GY-HM790CHU:
- Connection instruction (1 page) ,
- Instructions manual (144 pages) ,
- Service manual (31 pages)
Table of Contents
Advertisement
Shooting
Setting Spot Meter
(continued)
When [Manual] is selected
A
[SPOT METER FIXED] is displayed when the switch is
flipped. The brightness of the cursor position is displayed.
B
[SPOT METER OFF] is displayed when the switch is
flipped. Displays of cursors and brightness disappear.
C
[SPOT METER SELECT] is displayed when the switch is
flipped. The cursor blinks in red.
Move the cursor with the cross-shaped button (
specify the position to display the brightness. When the
position is decided, press the Set button (
switch to confirm.
D
Returns to the state in A.
Memo :
● When moving the cursor position, [SHUTTER]/
[AE LEVEL] control is disabled.
● You can also decide the position of the cursor with the Set
R
button (
).
● When the brightness is 0 % in the entire screen, the frame
is fixed in the center.
● If the cursor is outside the 4:3 range, changing the
[Aspect Ratio] item in the [Record Format] menu from
16:9 to 4:3 restores the cursor to the default position.
(A Page 75)
You can check (review) the last recorded video clip on the
screen.
However, the video clip cannot be played back if the settings
of the camera recorder are different from the video format
(Camera Resolution/Frame & Bit Rate) of the clip.
(A Page 75)
Memo :
Cursor (Green)
JKH I
) to
1
R
) or flip the
function during standby ( STBY is displayed).
Playback of the configured section starts.
Memo :
Cursor
(Blinks in red)
Viewing Recorded Videos
Immediately (Clip Review)
● To use this function, assign Clip Review to any of the
[USER1], [USER2], [USER3] buttons or the [RET] button
on the lens.
* [Main Menu] B [Camera Function] B [Switch Set] B
[LENS RET]/[USER1]/[USER2]/[USER3] B
Clip Review (A Page 79)
Press the button assigned with the Clip Review
● The video clip is played back according to the [Clip Review]
settings in the [Camera Function] menu. By default setting
(Last 5 sec), the last 5 seconds of the clip is played back.
(A Page 79)
● When playback is complete, the camera recorder exits Clip
Review and returns to STBY (recording standby) mode.
[RET] Button
Advertisement
Table of Contents
