Preparations
Attaching Accessories
Attaching the Zoom Lens
(Supplied with GY-HM790U/GY-HM790E only)
Hole
4
Clamp
1
Loosen the mount ring.
2
Attach the zoom lens such that the pin matches the
hole of the mounting area.
3
Tighten the mount ring.
4
Connect the cable connector.
5
Attach the lens cable to the clamp.
Memo :
● Tighten the mount ring completely. If it is not fully tightened,
the lens may drop or the back focus may be out of alignment.
● When attaching or removing the zoom lens, set the
[POWER] switch of the camera recorder to OFF .
Attaching the Microphone (Supplied)
You can attach the supplied microphone to the microphone
holder.
The supplied microphone has a phantom power supply.
1
Turn the knob on the microphone holder
anticlockwise to loosen and open the microphone
holder.
2
Place the microphone in the microphone holder.
3
Turn the knob on the microphone holder clockwise to
secure the microphone.
4
Connect the microphone cable to the [INPUT1] or
[INPUT2] terminal.
5
Pin the microphone cable to the clamp.
6
Make sure to perform the correct settings for the
phantom microphone (A Page 46).
3
Pin
1
2
Knob
[INPUT1/INPUT2] Terminal
Attaching the Viewfinder (Supplied)
1
Slide the viewfinder in the direction of the arrow to
attach it.
2
Turn the slide lock ring to secure the position of the
viewfinder.
Slide Lock Ring
2
1
3
Attach the viewfinder cable to the viewfinder terminal.
4
Pin the viewfinder cable to the clamp.
3
Microphone
Microphone Holder
Clamp
Viewfinder
4
Clamp