Table of Contents
Advertisement
Viewing Recorded Videos
Immediately (Clip Review)
You can check (review) the last recorded video clip
on the screen.
However, the video clip cannot be played back if
the settings of the camera recorder are different
from the video format (Resolution/Frame Rate/Bit
Rate/SD Aspect) of the clip.
(A P108 [ W Resolution ] )
(A P109 [ W Frame Rate ] )
(A P109 [ W Bit Rate ] )
(A P109 [ SD Aspect ] )
Memo :
To use this function, assign "Clip Review" to any
0
of the user buttons. "Clip Review" is assigned to
the [C.REVIEW/4] button in factory default.
"Clip Review" can also be assigned to other user
0
buttons.
(A P33 [Assignment of Functions to User
Buttons] )
.
1 Press the user button assigned with the
"Clip Review" function during standby
("STBY" is displayed).
Playback of the configured section starts.
Memo :
The video clip is played back according to the
0
setting in [Main Menu] B [Camera Function] B
[User Switch Set] B [Clip Review]. By default
setting (Last 5sec), the last 5 seconds of the clip
is played back.
(A P92 [ Clip Review ] )
When playback is complete, the camera
0
recorder exits Clip Review and returns to
"STBY" (recording standby) mode.
Caution :
During Clip Review, only the [CANCEL/STOP]
0
and [REC] buttons are enabled.
Press the [CANCEL/STOP] button to cancel clip
review and return to "STBY" (recording standby)
mode.
Press the [REC] button to cancel clip review and
enter recording mode. It will take some time to
start recording after the button is pressed.
When the last clip is less than 5 seconds, the
0
whole clip is played back.
Only video clips in the currently selected slot can
0
be reviewed.
When there are no clips in the selected slot, Clip
0
Review function is disabled.
Clip Review is unavailable when Clip
0
Continuous Rec is paused ("STBYC", yellow
text). To operate Clip Review, use the
[CANCEL/STOP] button to set to "STBYC"
(white text) first.
(A P73 [Clip Continuous Rec] )
Clip Review is unavailable when the camera
0
recorder is connected to an external equipment
and the equipment is in recording state.
Clip Review does not function while the SDI
0
record trigger is in the REC state.
Viewing Recorded Videos Immediately (Clip Review)
67
Advertisement
Table of Contents
