58
To carry out a system reset:
1. Select the System reset (RESET) screen in Dealer calibration.
+1
2. Press
3. The screen will then show an ARE YOU SURE message:
•
Press
or
•
Press
4. You will then see the CAL LOCK screen:
•
Hold down
the SPX-5 Tiller system computer power off and back on.
If you reset the system parameters, you must carry out the SPX-5 Tiller
system commissioning process before using the SPX-5 Tiller system again.
4.5 System defaults
Calibration Lock
Vessel Type
Drive Type
Rudder Alignment
Rudder Limit
Rudder Gain
Counter Rudder
Rudder Damping
AutoTrim
Response:
SmartPilot X-5 Tiller & GP Tiller Installation & Setup Guide
then press AUTO.
auto
to cancel the reset
+1
again to select YES and reset the SPX-5 Tiller system.
standby
for 2 seconds to save the new default settings, then turn
OFF
SAIL BOAT
3
0
30
2
2
2
1
5
Turn Rate Limit
Off Course Angle
AutoTack Angle
Gybe Inhibit
Wind Type
Wind Trim
Power Steer (Joystick)
Cruise Speed
Latitude
Autopilot Reset
7
20
Relative
ON
APP
5
OFF
8
0
OFF