Step 1 - Mount The Tiller Drive - Raymarine SmartPilot X5 Installation & Setup Manual

Chapter 2: Installing the system
If you need to adapt the standard installation, refer to Adapting the installation on
page 16 for adaptation options.

Step 1 - Mount the Tiller Drive

Use this procedure when neither accessories or adaptation of the drive unit position
are required.
1. Securely clamp the tiller, mark the pin position and drill the 6 mm (1/4") hole.
2. Fix the pin in position using a two-part epoxy adhesive.
3. Check the shoulder height of the pin.
1.
4. Mark the socket position and drill a 6 mm (1/4") pilot hole to check the thickness of
the structure. If this is less than 25 mm, reinforce with plywood and bond into
position. Once this has cured, open up the hole diameter to 12.5 mm (1/2").
5. Fix the socket in position using a two-part epoxy adhesive.
6. Once the epoxy has fully hardened, fit the tiller drive.
6 mm
(0.25 in)
12.5 mm
(0.5 in)
2.
3.
12.5 mm
Allow epoxy to fully harden
(0.5 in)
before applying load.
13
Two part
epoxy
adhesive
to fix tiller
pin in
place