Setting Up Data Pages - Raymarine SmartPilot X5 Installation & Setup Manual

48
The default data page settings are:
Data Page
1
2
3
4
Remaining pages

Setting up data pages

When setting up your data pages, we recommend:
• You set data pages you do not need to NOT USED, as these will then not be
displayed during normal operation, leaving just the data pages that you do want
for you to scroll to.
• You retain the BTW and DTW data pages. If your SPX-5 Wheel system receives a
man overboard (MOB) message, these data pages will show the bearing and
distance to the MOB location.
Available Data Pages
Speed Knots
Log
Trip
Average Speed
Wind Direction
Wind Speed
Depth Metres
Depth Feet
Depth Fathoms
Heading
Water Temperature, Degrees C
Water Temperature, Degrees F
Course Over Ground
Speed Over Ground, Knots
Cross Track Error
Distance to Waypoint
SmartPilot X-5 Tiller & GP Tiller Installation & Setup Guide
Default Setting
XTE (Cross Track Error)
BTW (Bearing to Waypoint) - see Note below
DTW (Distance to Waypoint) - see Note below
RESPONSE
Setting up data pages
NOT USED (see
Displayed as
SPEED KTS
LOG XXXX.X
TRIP XXX.X
AV. SPD
e.g. WIND PORT
WIND KTS
DEPTH M - see Note below
DEPTH FT - see Note below
DEPTH FA - see Note below
HEADING
WATER °C - see Note below
WATER °F - see Note below
COG
SOG KTS
XTE
DTW
below)