Raymarine SmartPilot X5 Installation & Setup Manual page 47

Chapter 3: Commissioning & setup
Enter Seatrial calibration
Prepare for AutoLearn
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
5. The screen will show the CLEAR TO MANEUVER message. Ensure it is safe to
continue, then press auto to start the AutoLearn maneuvers:
• The boat will start a series of zig-zag turns and the display will show LEARNING
with a number to indicate the current AutoLearn stage. This number increases
as AutoLearn progresses.
• A typical AutoLearn completes within 7 to 27 steps (depending on boat
characteristics and sea conditions).
Note:
To cancel an AutoLearn, press standby or disp.
6. When the SPX-5 Tiller system has finished learning, the controller will beep and
display either LRN PASS or LRN FAIL:
• LRN PASS = AutoLearn completed successfully.
• LRN FAIL = AutoLearn was not successful, so should be repeated. One of the
following failure codes will also be displayed:
1 = AutoLearn has not been carried out.
2 = AutoLearn failed, due to manual interruption.
4 = AutoLearn failed, probably due to drive or compass failure.
5 = AutoLearn failed, probably due to motor current limiting.
6 = AutoLearn failed, probably due to boat spinning.
7. If the AutoLearn was successful, hold down standby for 2 seconds to store the
new settings.
2 sec
x4
CHECK!
Before proceeding, ensure
you have sufficient clear
sea space
x2
AutoLearn in progress
Start
AutoLearn
39
D10545-1