Pedestal Socket - Raymarine SmartPilot X5 Installation & Setup Manual

Chapter 2: Installing the system
To use the cantilever socket:
1. Use a hacksaw to cut the rod to length L = F - 635 mm (25").
2. Assemble the mounting ring, rod and socket.
3. With the drive horizontal mark the location of the mounting ring and its holes.
4. Drill three 6 mm (1/4") diameter clearance holes at the marked positions.
5. Apply a thin coat of silicone sealant to the base of the mounting ring.
6. Use three 6 mm (1/4") diameter bolts, nuts and washers to attach the mounting
ring and backing plate.
7. Roughen the end of the rod and inside of the socket to provide a key. Then apply
two-part epoxy adhesive to the rod end and cap.
8. Place the cap over the rod end, making sure the hole faces upwards. Allow the
adhesive to harden fully before applying a load.
Note:
Note: When the autopilot is not in use, you can unscrew the complete rod assembly to
leave the cockpit unobstructed

Pedestal socket

Use the pedestal socket if you need to raise the height of the socket to make the tiller
drive horizontal.
To use a pedestal socket:
1. Select a socket assembly with a length L, nearest to G -38 mm (1.5").
2. With the drive assembled, and the socket positioned 460 mm (24.5") from the tiller
axis mark the location of the mounting ring and holes.
3. Drill three 6 mm (1/4") diameter clearance holes at the marked positions.
4. Apply a thin coat of silicone sealant to the base of the mounting ring.
5. Use three 6 mm (1/4") diameter bolts, nuts and washers to attach the mounting
ring and backing plate.
Note:
Note: When the autopilot is not in use, you can unscrew the complete rod assembly to
leave the cockpit unobstructed.
L
G
17