Mobotix D14D Manual page 57

First Installation Steps
9. Mount the dome: Pick up the dome using the
supplied plastic foil or a cotton cloth and screw the
transparent dome in a clockwise direction onto the
housing until the dome sits securely (but not too
tightly) in the seal.
Make sure that the dome is not tilted and that it is
securely fitted to the seal on all sides.
10. Attach the outer shell: Hold the outer shell so that
the round hole of the shell is positioned over the
PIR sensor of the camera. Gently press the shell
into the shell's seats in the camera housing. Old
outer shells (D10D, D12D) may no longer be used!
If the camera is mounted on an outdoor ceiling and is exposed to extreme conditions, the
three holes in the outer shell should be sealed with commercial silicon in order to prevent water
from entering the outer shell.
Special Case: Mounting The D14D-180° To A Wall Without The Wall Mount
The lens mount unit has to be rotated by 180° so that you do not get an upside down panorama
image in the vertically mounted camera (PIR sensor points downwards, see Section 2.1.1):
• Loosen the two sensor cables from the clamping rails on both sides.
• Remove two Allen screws on both sides of the lens mount.
• Pick up the lens mount and rotate by 180 degrees. Do not tear or jam the cable in
the process.
• Reposition and mount the lens mount.
Due to the associated environmental conditions, the sensor boards may be exposed
to a relatively high temperature that is however harmless for camera functioning.
Sensor boards should not be directly touched while the camera is running (let them
cool down first).
Make sure that the sensor cable is not damaged or disconnected when aiming
the lens.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Caution
57
/132