Power Supply Using A Switch - Mobotix D14D Manual

Network And Power Connection
The MOBOTIX factory default is PoE class 2. This default is usually fine and nothing needs
to be changed. However, the PoE power class must be changed in the browser if the
higher power class 3 is required for your application:
1. Select Admin Menu > Network Setup > Ethernet interface
(for experts).
2. Under Power Supply, click on Change.
3. A Power Wizard will appear to guide you through the PoE
configuration steps.
4. Next, restart the camera: Disconnect the camera from the
power supply. Then reconnect it, for example, by disconnecting
and then reconnecting the Ethernet cable at
the PoE switch.

2.7.3 Power Supply Using A Switch

1. Connect the factory pre-installed cable of the
camera to the Camera connector of the PoE
adapter.
2. Connect the LAN/Power connector of the
PoE adapter to the Ethernet connector of the switch/router or the Ethernet socket.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector of
the PoE adapter.
Switch/router
LAN/www
(10.8.0.11/255.0.0.0)
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
PoE Adapter
(MX-NPA-PoE)
Camera
RJ45
PC
Power supply
Camera
(10.8.0.99)
77
/132
Variable PoE: multiple
cameras can be operated
simultaneously from
the same switch
The IP addresses in
the diagram are shown
only as an example
For the D14D,
you should use the blue
MX-NPA-PoE Set –
previous MOBOTIX
network power
accessories such as the
NPA Set, Power Box,
and Power Rack
(MX-NPA-Set,
MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the D14D