When Removing The Plasma Display - Pioneer PDP-425CMX Technical Manual

Wall Mount Unit: PDK-WM01
8 With the lock bar in the lock position, fixing the lock
plate firmly in place with push rivet and the anchor
screw (M6 x 14 mm (9/16 inch)) (1 location: left and
right sides) removed in step 1 (1 location: left and right
sides).
• If there are speakers installed on both sides
Fix it in place with the anchor screw (M6 x 14 mm (9/
16 inch)) removed in step 1 (*1).
• If there is a speaker installed on the bottom and
if a PDP-436SX is installed
Fix it in place with the anchor screw (M6 x 14 mm (9/
16 inch)) removed in step 1 (*2).
76
Locked
Unlocked
position
position
Lock bar in the lock
position.
Anchor screw (*2)
Anchor screw (*1)

4.7.4 When removing the plasma display

Before beginning this procedure, turn off the
power to the plasma display and peripheral
devices and remove their power plugs from the
Caution
outlets. As necessary, also remove connecting
cables.
1 Loosening the screw on the tilt adjustment metal
fitting.
Note
Removing the plasma display without removing the
tilt adjustment metal fitting may scratch the wall.
2 Removing the push rivet and the anchor screws that
are holding the lock plate, and the anchor screws
that are holding the PDP metal fitting (2 locations on
the left and right).
Anchor screw
Lock plate
3 Unlocking the lock bar (2 locations on the left and right).
Push rivet
Anchor screw
Lock
bar
Locked
Unlocked
position
position
Set the lock bar in its
unlocked position