Baud Rate Setting - Pioneer PDP-425CMX Technical Manual

12) BAUD RATE Setting

It is possible to switch the RS-232C transmission speed (baud rate) when control or adjusting the display using a PC.
The baud rate can be set among six stages: 1200 bps, 2400 bps, 4800 bps, 9600 bps, 19200 bps and 38400 bps.
Factory setting: 9600 bps
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode (pg. 134)".)
Select 'OPTION'.
2 Place the cursor on 'BAUD RATE', and press the [SET]
button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 4800BPS
2
2400BPS
The 'BAUD RATE' setting is common for all inputs.
Set the baud rate of the display so that it matches the baud rate of the PC.
Also, if the RS-232C cable must extend over a long distance, it is recommended that the baud rate be set lower.
3 3
9600BPS 19200BPS
2 38400BPS 2
1200BPS
Integrator Mode
Screen 2
I N T E G R AT O R
P I C T U R E S C R E E N
P R O G R A M T I M E R
S C R E E N M A S K
S I D E M A S K
V I D E O WA L L
B A U D R A T E
I D N O . S E T
CHANGE
SET
I N P U T 1
S E T U P O P T I O N
:
G R E E N
:
3 8 4 0 0 B P S
:
1
EXIT
MENU
151