Pioneer PDP-425CMX Technical Manual page 61

Regarding the stand pipe screw holes when the stand is
used as a desktop stand
Stand pipe screw holes when the stand is used as a desktop
stand
• Specifications .............................................. Normal use
• Screw holes used with stand orientation ... A, A'
Note
Screw holes B and B' are for attaching options available sepa-
rately.
2 Hook the stand pipe holes A onto the screw heads of the installation bolts 1, then slide the stand upwards to the
main plasma display until it engages the installation bolts 1 (once put together with the display, the stand will slides
no more than 19 mm).
3 Pass the installation bolts 2 (M8 × 40) through the stand pipes and tighten the installation bolts securely with the
included hexagonal wrench (holes should be used in the proper A–A').
4 Tighten the installation bolts 1 securely with the hexagonal wrench provided.
1. Place a sheet or protective cover to protect the display from scratches or damage.
2. Assemble only with the plasma display lying flat on a table or similar surface.
3. Do not apply excessive pressure and tighten the bolts more than necessary.
Cautions
4. Move the stand so that the stand screw holes and the nuts that connect the main display line up
correctly.
5. The display weighs approximately 30 kg (66 lbs.) or more and has little depth, making the display
very unstable. For this reason at least two people are necessary for its setup and installation.
Table top stand
B
A
B ´
A ´
Installation bolts 2 (M8 × 40)
Slide the stand
Sheet
Table Top Stand: PDK-TS01
B
A
B ´
A ´
61