When Removing The Plasma Display - Pioneer PDP 427CMX Technical Manual

Wall Mount Unit: PDK-WM01
8 With the lock bar in the lock position, fix the lock plate
firmly in place with push rivet and the anchor screw
(M6 x 14 mm (9/16 inch)) (one location: left and right
sides) removed in step 1 (one location: left and right
sides).
• If there are speakers installed on both sides
Fix in place with the anchor screw (M6 x 14 mm (9/
16 inch)) removed in step 1 (*1).
114
Locked
Unlocked
position
position
Lock bar in the lock
position.
Anchor screw (*1)

4.7.4 When removing the Plasma Display

Before beginning this procedure, turn off the
power to the Plasma Display and peripheral
devices. Remove the power plugs from the
Caution
outlets. Also remove connecting cables if
necessary.
1 Loosening the screw on the tilt adjustment metal
fitting.
Note
Removing the Plasma Display without removing the
tilt adjustment metal fitting (may scratch the wall).
2 Remove the push rivet and anchor screws that are
holding the lock plate. Then, remove the anchor
screws that are holding the PDP metal fitting (two
locations on the left and right).
Anchor screw
Lock plate
3 Unlock the lock bar (two locations on the left and right).
[507CMX : 427CMX]
Push rivet
Anchor screw
Lock
bar
Locked
Unlocked
position
position
Set the lock bar in its
unlocked position