Pioneer PDP-425CMX Technical Manual page 31

Methods of Securing: Basic methods of securing are shown below. Avoid blocking or covering areas aside from those
indicated by
Before attaching the unit to fittings, double-check that the thickness and height of the fittings,
and the number of fixing bolts is correct.
(Also refer to "3.4.1 Mounting to fittings (pg. 28)".)
Note
Heated air is drawn off from the interior of the unit by fans. Before installation, consider the heat resistance of the
wall or other surfaces behind the unit. Exhaust temperatures can be 30 °C higher than the outside temperature.
Note
For wall-mounting, do not bundle the cables in a way that will obstruct ventilation.
300 mm or
more
300 mm or
more
Flush-wall installation
(distance between unit and wall
less than 50 mm)
Requirements :
• Free air flow (With no obstructions
within a distance of 300 mm from
the unit)
• Temperature of 0 °C to 35 °C
Special Installation (Hanging on the wall)
. The method indicated by a large X-mark must not be used.
100 mm or more
50 mm or
more
50 mm or more
Ex.: Installation requirements when
installed in recess in wall
Wall-mounted installation
(distance between unit and wall
greater than 50 mm)
Requirements :
• Free air flow (With no obstructions within
a distance of 300 mm from the unit)
around all four sides of the unit is not
necessarily required when the unit is
installed at a distance of greater than 50
millimeters away from the wall.
* Note, however, that in such cases the unit
may not be placed behind a glass panel or
any other obstruction which would create
a closed space.
• Temperature of 0 °C to 40 °C
Panting net
100 mm or more
50 mm or
more
100 mm or more
Ex.: Installation when covered with a
Panting net
Wall-embedded installation
(i.e., installation in closed space)
(distance between unit and wall
greater than 50 mm)
Requirements :
• See "3.4.3 Embedding in the wall (pg.
32)" for installation requirements.
• Temperature of 0 °C to 40 °C
100 mm or more
100 mm or more
31