Normal Operation Mode; About Normal Operation Mode - Pioneer PDP-425CMX Technical Manual

Normal Operating Mode

5.2 Normal Operation Mode

5.2.1 About normal operation mode

The following controls are possible in the normal operation mode.
1 Switching input
• Pressing the [INPUT1] to [INPUT5] buttons on the remote control changes the input to INPUT1 to INPUT5.
• Pressing the [INPUT] button on the main-control panel changes the input each time the button is pressed.
Note
When PDA-5003/PDA-5004 is not installed, the input is switched only between INPUT1 and INPUT2.
2 Switching the screen size
• Each time the [SCREEN SIZE] button on the remote control or main-control panel, the display screen size changes.
When reproducing a video signal (signal other than a PC signal) # (Applicable only when a PDA-5003/PDA-5004 is
mounted.)
3
4:3
14:9 2
When reproducing a PC signal
3
DOT BY DOT/FULL
Notes
• The reproducible screen size changes according to the input signal.
Refer to the section 5.1.3, "List of Input Correspondence Signals (pg. 96)".
• To select 'Underscan', a PRO USE setting in the integrator mode is necessary.
When this display is to be used for commercial use or for public viewing, such as in a coffee shop or hotel,
reducing or enlarging the screen by using the screen-size-switching function could infringe on the copyright of
the creator according to copyright laws.
2 Display call
A Pressing the [DISPLAY] button on the remote control or main-control panel will display the current input function,
horizontal and vertical frequency of the input signal, the type of signal, and screen size (DISPLAY CALL 1).
Note
The horizontal and vertical frequencies that are displayed are measured values. Measurement errors are possible.
B Pressing the [DISPLAY] button on the remote control or main-control panel again for 3 seconds or more when the
display described in A above is displayed, various settings and internal temperature will be displayed as shown in
the screen below (DISPLAY CALL 2).
P D P - 4 2 5 C M X / LV C 5
S E R I A L N O.
L OT
DAT E
H O U R M E T E R
T E M P E R AT U R E
O S D
B AU D R AT E
FA N C O N T R O L
I D N O. S E T
C O L O R M O D E
I N F O R M AT I O N
: A B C D E F G H I J K L M N
Note
When the temperature display is high temperature, it shuts down, but the display should always be used as an
indicator.
108
3 3
FULL WIDE
2.35:1 2 ZOOM 2
3 3
FULL
4: 3
: * * * * * * * * * * * * * * * *
: 0 0 1 A 0 0 1 K
: 0 0 1 A 0 0 1 X
: 0 0 2 3 9 H
: + 2 5
: O N
: 9 6 0 0 B P S
: AU TO
: A L L
: N O R M A L
SERIAL NO.: Displays the serial number of the product.
LOT/DATE: Displays the manufacturing control number.
HOUR METER: Displays the conduction time for the product.
TEMPERATURE: Displays the outside air temperature that is
measured by a temperature sensor located in
the product.
Other items: Displays the settings in the integrator mode.