Screen Mask Setting - Pioneer PDP-425CMX Technical Manual

9) SCREEN MASK Setting

This function displays the inverse of the normal display on the entire screen, or displays a single color such as white,
red, green or yellow according to an internal signal in the plasma display.
When setting something other than 'OFF' or 'INVERSE' it is not possible to display a signal input from the outside.
When this function is used when the screen has been burned, it may be used as an emergency measure for relieving
the problem (It is not possible to completely remove the burning).
For details, refer to section 5.6, "Screen Burning (pg. 185)".
Factory setting: OFF
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode (pg. 134)".)
Select 'OPTION'.
2 Place the cursor on 'SCREEN MASK', and press the [SET]
button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 3
OFF INVERSE
2
YELLOW
OFF: The normal display is displayed.
INVERSE: The RGB levels of the display are inversed with
respect to the normal display.
WHITE, RED, GREEN, BLUE, YELLOW: Only the selected color is displayed.
Notes
• When YELLOW is set for the SCREEN MASK, the BLUE component is half with respect to WHITE.
• In a mode other than OFF, operation is performed after the OSD display ends.
The 'SCREEN MASK' setting is common for all inputs.
3 3
WHITE RED
2 2
GREEN
BLUE
Integrator Mode
Screen 2
I N T E G R AT O R
P I C T U R E S C R E E N
P R O G R A M T I M E R
S C R E E N M A S K
S I D E M A S K
V I D E O WA L L
B A U D R A T E
I D N O . S E T
CHANGE
SET
I N P U T 1
S E T U P O P T I O N
:
G R E E N
:
3 8 4 0 0 B P S
:
1
EXIT
MENU
145