Powertech 2-Wire; Powertech 3-Wire - Trace Engineering RC7 Installation And Operator's Manual

a.

PowerTech 2-wire

Connect the generator as shown below.
COM. GEN START 1
N.O. GEN START 2
N.C. GEN RUN 3
COM. GENRUN 1
N.O. GEN RUN 2
INVERTER/CHARGER
b.

PowerTech 3-wire

Connect the generator as shown in below.
COM. GEN START 1
N.O. GEN START 2
N.C. GEN RUN 3
COM. GENRUN 1
N.O. GEN RUN 2
INVERTER/CHARGER
WARNING: WHEN STORING AN RV/RC7GS EQUIPPED VEHICLE INDOORS,
ENSURE THE AUTO GEN START FEATURE IS DISABLED BY RESETTING
THE GENERATOR START FUNCTION TO "MANUAL (PUSH ON)." REFER TO
THE RC7GS SETUP MENU SECTION. FAILURE TO DO SO MAY ALLOW THE
GENERATOR TO RUN WHEN THE AUTO-START PARAMETERS ARE MET
PRODUCING DANGEROUS EXHAUST FUMES.
1 999 Trace Engineering
ã
RC7 & RC7GS Remote Controls
5 A
5 A
Figure 68
PowerTech 2-Wire
START 5 A
GROUND
STOP 5 A
Figure 70
PowerTech 3-wire
Generator Start:
Manual (Push ON)
Figure 71
Select MANUAL Start for Storage
RED (from start/stop switch)
WHITE/RED (from start/stop switch)
2-WIRE CONFIGURATION
822-4A-009
GROUND
BLUE (start wire)
YELLOW (stop/preheat wire)
3-WIRE CONFIGURATION
822-4A-010
3.0 OPERATION
35