High Battery Voltage; Low Battery Voltage - Trace Engineering RC7 Installation And Operator's Manual

RC7 & RC7GS Remote Controls
3.0 OPERATION
3.

High Battery Voltage

The "Hibat/Stop Chrg" System Status message is displayed when the
battery voltage is too high. Switch off any other charging sources to allow the
voltage level to drop. The inverter automatically resets and resumes operation
when the battery reaches a safe voltage level. This condition usually occurs only
when an additional charging source is used to charge the battery bank.
NOTE: Press any arrow push-button to cancel the buzzer.
4.

Low Battery Voltage

The "Lobat/Start Chrg" System Status message is displayed when the
battery voltage drops below a safe level. The red Error LED illuminates and the
Buzzer sounds. The inverter shuts off to prevent damage to the batteries.
Provide an ac supply (such as shore power or a generator) to the inverter/
charger to automatically start charging the batteries.
NOTE: Press any arrow push-button to cancel the buzzer.
26
Inverter
Charge
Batt. Full
Error
Error LED ON
Error Display–High Battery Voltage
Inverter
Charge
Batt. Full
Error
Error LED ON
Error Display–Low Battery Voltage
Error Condition
System Status:
Hibat/Stop Chrg
822-4A-001
Figure 49
Error Condition
System Status:
Lobat/Start Chrg
822-4A-001
Figure 50
Remedy
Buzzer Sounds
Remedy
Buzzer Sounds
1 999 Trace Engineering
ã