2.
3.
4.
5.
6.
7.
34
IBM : Hardware Maintenance Manual
If the drive you are installing is a removable-media drive, remove the bay panel
from the front bezel.
Remove the metal shield from the drive bay by inserting a flat–blade screwdriver
into one of the slots and gently prying it loose.
Make sure the drive is set correctly as the master device. Refer to the
documentation that comes with your CD drive or DVD drive for master/slave
jumper information.
Pivot the drive bay latch handle toward the front of the computer and pivot the
drive bay cage upward, as shown, until it is latched in the up position.
Install the drive into the bay. Align the screw holes and insert the two screws.
Each integrated drive electronics (IDE) drive requires two cables; a four-wire
power cable that connects to the power supply, and a signal cable that connects to
the system board.
To connect a CD drive or DVD drive to your computer, follow these steps.