IBM 6343 Hardware Maintenance Manual page 10

6.
7.
DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to 002 .
If YES, proceed to 003 .
If the Power Management feature is enabled, do the following:
1.
2.
3.
4.
5.
6.
7.
Run the Diagnostic programs. If necessary, refer to "Diagnostics" on page 16.
•
•
2
IBM : Hardware Maintenance Manual
Power-on the computer.
Check for the following response:
• Readable instructions or the Main Menu.
002
Start the Configuration/Setup Utility program (see "Setup Utility program" on
page 14)
Select Power Management from the Configuration/Setup Utility program menu.
Select APM.
Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (← ) or
Right Arrow (→ ) to change the setting.
Select Automatic Hardware Power Management.
Set Automatic Hardware Power Management to Disabled.
If the problem persists, continue to 003 .
003
If you receive an error, replace the part that the diagnostic program calls out or go
to "Symptom-to-FRU Index" on page 69.
If the test stops and you cannot continue, replace the last device tested.