Removing The Dummy Module - Fujitsu Primergy RX600 S2 Operating Manual

Memory boards
Ê Press the green latch (2).
The green handle (1) is released.
Bild 29: Pulling out a memory board
Ê Pull out the memory board in the direction of the arrow (1), grasping it by the
green handle.
Ê To insert a new memory board, continue with section "Inserting a Hot-plug
Memory Board" on page 83.
V
CAUTION!
If the memory board is removed and not replaced with a new board, then
the dummy module must be reinstalled due to cooling, the applicable
EMC (electromagnetic compatibility) regulations and fire protection.
Make sure that the dummy module engages correctly in its location.
8.4.2

Removing the Dummy Module

All memory board locations are provided with dummy modules which must be
removed before inserting a new memory board.
Ê Remove the cover (see "Opening/Closing the Casing" on page 94).
Ê Insert your fingers into the two holes on the top of the dummy module.
Ê Push the tab between the two holes in the direction of the arrow and pull out
the dummy module.
I
Keep the dummy module for future use.
82
1 2
Hot-plug Components
1
A3C40069794