Intercharacter Delay; Usb Com Interface Set-Up - Datalogic Magellan 800i Reference Manual

Interface Related Features
USB Keyboard — cont.

Intercharacter Delay

START / END
If the transmission speed is too high, the system may not be able to receive all characters. You may need to adjust the delay to make
the system work properly. Selectable from 00 to 99.
USB Keyboard: 00 = 1 ms USB Host poll rate. Non-zero values less than 25 are 10 ms increments in USB Host poll rate values
greater than 25 result in a USB Host poll rate of 255 ms.
To configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode, then the "Set Intercharac-
ter Delay," followed by the two digits (zero padded) from the Alphanumeric table in
your desired length. Exit programming mode by again scanning the "START/END" bar code above/
0287(CR)

USB COM Interface Set-up

To set the reader to use the USB Com interface, follow these instructions:
1. Download and install the USB Com driver available from the www.datalogic.com web-
2. Program the reader for the USB Com interface using the bar code located on
3. Plug and play.
46
PROGRAMMING BAR CODES
DEFAULT SETTING FOR THIS FEATURE:
site.
Appendix C, Alphanumeric Pad
01
Set Intercharacter Delay
representing
.
page 26
Magellan TM 800i