Cell Phone Mode; Cell Phone Mode Sensitivity - Datalogic Magellan 800i Reference Manual

Cell Phone Mode

Cell phone mode is when the scanner is enabled to read barcodes on a cell phone display. This
mode is set as follows:
•
•
•
START / END
03E000(CR)
Cell Phone Mode = Auto
03E002(CR)

Cell Phone Mode Sensitivity

When Cell Phone Mode is configured for "Auto" for a scanner, it will go into cell phone mode
based on what is seen in its field of view. (The illumination LED's will "flutter" slightly when
entering cell phone mode.) By default, medium sensitivity is selected. If the scanner is going
into cell phone mode more often than the user would like, the scanner can be set to low sensitiv-
ity by scanning the low sensitivity programming labels on the following page. If the scanner
does not seem to go into cell phone mode often enough, the scanner can be set to high sensitiv-
ity by scanning the high sensitivity programming labels.
Product Reference Guide
Disabled - No cell phone mode
Auto - Will automatically go to cell phone mode
Manual - Will go to cell phone mode on receiving a command from the host. See
Appendix F, Host Commands
PROGRAMMING BAR CODES
for more information regarding this feature.
Cell Phone Mode = Disable
Cell Phone Mode = Manual
Cell Phone Mode
DEFAULT
03E001(CR)
23