Ack Nak Retry Count - Datalogic Magellan 800i Reference Manual

Interface Related Features
RS-232 Interface Features — cont.

ACK NAK Retry Count

START / END
This feature sets the number of times for the scanner to retry a label transmission under a retry condition.
000 = No retry
001 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode, then the "Set ACK NAK
Retry Count," followed by the three digits (zero padded) from the Alphanumeric table in
ing your desired retry count. Exit programming mode by again scanning the "START/END" bar code above
0608(CR)
38
PROGRAMMING BAR CODES
DEFAULT SETTING FOR THIS FEATURE: 003
Appendix C, Alphanumeric Pad
Set ACK NAK Timeout Value
represent-
Magellan TM 800i