Cloning; Iconnecting The Transceiver; Ireceiving The Master Data; Itransmitting Data From The Master Transceiver - Alinco DJ-C7T Instruction Manual

7. Cloning

7.1 Cloning
With the Cloning function, it is possible to connect two
transceivers by a cable, and copy all settings from one unit
(called the Master) to the other (called the Slave).
This function transfers all the settings of the Master including
memory channel data.

IConnecting the Transceiver

• Connect both of the speaker jacks on the sending transceiver
(Master side) and the receiving transceiver (Slave side) with a
ø 2.5 stereo mini-plug cord as shown in the below illustration.
• Be sure that both transceivers are switched OFF before
connecting them.
Master
To SP/MIC connector
on the transceiver

IReceiving the Master Data

Here are the operations of the Slave side.
1. While holding the MONI key down, turn the power ON.
" " is displayed on the LCD, and the Slave enters the
Clone mode.
Slave
To SP/MIC connector
on the transceiver
2. Wait for a while until the master data is transferred
completely.
For more information on sending the master data, please refer
to the next section.
3. Turn the power OFF on the Slave.
• The stereo mini-plug cord should be direct-coupled to avoid
internal resistance.
• Even while the DJ-C7 transfers data, the operation can be
suspended with any key operations. To restart transferring,
press the PTT key.
• Do not disconnect the cable while cloning. When the cord is
disconnected, " " is displayed on the Master's LCD, and
the DJ-C7 suspends transferring.
• All data in the slave side will be overwritten if cloning is
executed. Be careful with current data on the Slave before
cloning.

ITransmitting Data from the Master Transceiver

Here are the operations of the Master side.
1. While holding the MONI key down, turn the power ON.
" " is displayed on the LCD, and the Master enters the
Clone mode.
7
27